General Description :

IP1IP101G is an IEEE 802.3/802.3u compliant single-port Fast Ethernet Transceiver for both 100Mbps and 10Mbps operations. It supports Auto MDI/MDIX function to simplify the network installation and reduce the system maintenance cost. To improve the system performance, IP101G provides a hardware interrupt pin to indicate the link, speed and duplex status change. IP101G provides Media Independent Interface (MII) or Reduced Media Independent Interface (RMII) to connect with different types of 10/100Mb Media Access Controller (MAC). IP101G is designed to use category 5 unshielded twisted-pair cable or Fiber-Optic cables connecting to other LAN devices. A PECL interface is supported to connect with an external 100Base-FX fiber optical transceiver.

Except good performance, reliability, rich power saving method and extreme low operating current, IP101G provides a serial tool for system designers to complete their projects easily. They are System Debug Assistant Tool and EMI Management Tool.

IP101G is fabricated with advanced CMOS (85nm) technology and design is based on IC Plus’s 5th Ethernet-PHY architecture, this feature makes IP101G consumes very low power. Such as in the full load operation (100Mbps_FDX), it only takes below 0.15W.

Feature :

• 10/100Mbps IEEE 802.3/802.3u compliant Fast Ethernet transceiver
• Supports 100-Base-TX/Fx Media Interface
• Supports MII/ RMII Interface

• Supports Auto MDI/MDIX function

• Power Management Tool
  -  APS, auto power saving while Link-off
  - 802.3az, protocol based power saving

  - WOL+, light traffic power saving

  - PWD, force-off power saving

• Supports Base Line Wander compensation

• Supports Interrupt function

• Supports MDC and MDIO to communicate with the MAC

• EMI Management Tool
  - F/W based control
  - 4 levels for mapping the difference layout length on the PCB

• Single 3.3V power supply

•  Built-in Vcore regulator

• DSP-based PHY Transceiver technology

• System Debug Assistant Tool
  - 16 bit RX counter
  - 9 bit RXER/CRC counter

  - Isolate MII/RMII

  - RX to TX Loopback

  - Loopback MII/RMII

• Using either 25MHz crystal/oscillator or 50MHz oscillator REF_CLK as clock source

• Built-in 49.9ohm resistors for simplifying BOM

• Flexible LED display

• Process: 85nm

• Package and operation temperature
  - IP101G: dice, 0~70℃
  - IP101GA: 48LQFP, 0~70℃

  - IP101GR: 32QFN, 0~70℃

  - IP101GRI: 32QFN, -40~85℃

Feature :

• NAS

• Network Printers and Servers

• IP Set-Top Box

• IP/Smart TV
• Game console

• IP and Video Phone

• PoE

• Telecom Fiber device